CAB A8+ Manual del operador descargar pdf (Pagina 59)

59cab Produkttechnik GmbH & Co KG

Transfer print

This parameter is used to set the printer's method of printing to thermal transfer

printing or direct thermal printing. The setting affects two factors directly

related to thermal transfer mode. First, for thermal transfer mode, the

printhead requires a lower temperature than when in direct thermal printing

mode. Second, the ribbon sensor is active. The setting for transfer print for a

single print job can be overwritten with software.

Warn level ribbon

That parameter allows to define a threshold diameter of the ribbon supply roll.

As soon as the diameter of the roll falls below this threshold a SNMP or E-mail

warning message is sent via Ethernet interface.

So the operator is already asked to prepare a new ribbon roll when the printer

is still running.

If your printer has no Ethernet interface, the diameter of the ribbon supply roll

can be asked by the q r command (see Programming Manual) using the serial

interface. This method is also available if the parameter "Warn level ribbon" is

set to "Off".

Label sensor

The printer offers two methods for recognizing the start of label. In most

cases, the label edge sensor photocell can be used in the "shine-through"

mode ("Gap sensor" mode), where the differing opacities between the label

area and spaces between labels is distinguished. In certain special cases, (ie.

pre-printed endless material), recognition of the start of the label can be made

via reflective markings on the bottom side of the label material.

This parameter can also be changed using software. For different print jobs it

is recommended that you make the change in the software.

The setting "Endless media" is especially intended to synchronize the feed of

continuous material in cut mode after switching on the printer.

You can find detailed information in the cutter documentation.

Tear-off mode

When the "Tear-off mode" is active, an additional feed forward will take place

after completion of the print job. This additional feed makes it possible to cut

or tear off the last label at the tear-off plate. When a new print job is started,

the label material will be fed back until the front edge of the first label is

repositioned under the printhead.

If the parameter is OFF, the label feed forward stops immediately after the last

label has completely passed the printhead.

8. Printer Configuration

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 119 120

Sin comentarios

CAB A8+ Manual del operador Pagina 59