CAB A8+ Manual del operador descargar pdf (Pagina 101)

B-3cab Produkttechnik GmbH & Co KG

Possible Cause

Hardware error

The data receive buffer is full but the

computer is still sending data.

Refers to the optional memory card;

No more data can be stored on the

card.

Optional "Cutter" error.

The cutter is unable to cut the media

due to the thickness;

The Cutter blades cannot return to the

home position and stay in an

undefined position.

Optional "Cutter" error.

The cutter is unable to cut the media

due to the thickness, but the Cutter

blades are able to return to the home

position.

Hardware error on the optional

"Cutter".

Hardware error

Error

ADC malfunction

Buffer overflow

Card full

Cutter blocked

Cutter jammed

Cutter stuck

dRAM

malfunction

Table B-3 Error Messages

Solution

Switch printer off, then on again.

If error reoccurs, contact Service.

Make sure you are using the RTS/

CTS protocol to send data.

Replace the card.

Switch printer off, remove media

from the cutter and turn the printer

on. If the error message continues,

contact Service. Otherwise, check

the thickness of the media and

replace if necessary.

Switch printer off and check the

media in the cutter area for

possible double layering or folding.

Start a test cut by pressing the

key. If the error reoccurs,

replace the media.

Switch printer off, then on again.

If error reoccurs, contact Service.

Switch printer off, then on again.

If error reoccurs, contact Service.

List of Error Messages

The following table contains an overview of possible error messages, possible

causes and solutions. Errors that can be recovered are marked with " * ".

If the solution does not solve the problem, call for Service.

Appendix B - Error Messages / Problem Solution

1 2 ... 96 97 98 99 100 101 102 103 104 105 106 ... 119 120

Comentarios a estos manuales

Sin comentarios

CAB A8+ Manual del operador Pagina 101

Comentarios a estos manuales

Relacionado con productos y manuales para Impresoras De Etiquetas CAB A8+