CAB A8+ Manual del operador descargar pdf (Pagina 108)

C-2 cab Produkttechnik GmbH & Co KG

Cleaning the Printhead

During printing, the thermal printhead will accumulate dirt such as paper dust or

particles of color from the ribbon. This accumulation can caused a

deterioration of the print quality (contrast difference of the label, appearance of

clear vertical stripes). To correct or avoid these types of problems, the

printhead should be cleaned at regular intervals:

Direct Thermal Printing : every media roll change

Thermal Transfer Printing : each ribbon change

CAUTION !

Do not use sharp objects for cleaning the printhead !

Do not touch the protective layer of the printhead with your hands!

Clean the printhead as follows :

1. Open the printhead as far as possible.

2. Remove the media and ribbon from the printer.

3. Clean the surface of the printhead with a cleaning pen, or use a cotton swab

dipped in isopropyl alcohol.

4. Let the printhead dry approximately 2 to 3 minutes before powering-on and

restarting the printer.

Appendix C - Maintenance / Cleaning

1 2 ... 103 104 105 106 107 108 109 110 111 112 113 ... 119 120

Sin comentarios

CAB A8+ Manual del operador Pagina 108