CAB A8+ Manual del operador descargar pdf (Pagina 112)

D-4 cab Produkttechnik GmbH & Co KG

Replacing the Print Roller

Fig. D-4 Changing Print Roller (I)

1. Open the printhead and swing down the plate (9) as shown in figure D-4.

Remove the media from the printer.

2. Take the Allen key (7), loosen the screws (3) and remove the tear-off plate

(2).

3. Remove two screws (5a, 5b) using the Allen key (7). Remove the pin (8)

using a 7mm hex wrench.

4. Remove the plate (6) and the printhead support (4) from the axle of the

print roller (1).

WARNING !

Unplug the power cord from the power source before starting!

Appendix D - Replacing Assembly Units

1 2 ... 107 108 109 110 111 112 113 114 115 116 117 118 119 120

Sin comentarios

CAB A8+ Manual del operador Pagina 112