CAB A8+ Manual del operador descargar pdf (Pagina 111)

D-3cab Produkttechnik GmbH & Co KG

4. To lift the printhead assembly, swing the lever (6) clockwise until it stops.

5. Remove the printhead (1) from the pins (12) on the printhead carriage.

6. Carefully unplug the printhead (1) from the connectors of the printhead

cables (10 and 11).

7. Connect the new printhead to the cables.

8. Place the printhead into the assembly and insert the holes (8) onto the

pins (12).

9. Tighten the locking screw (5) by hand. Check that the printhead is

completely secured in the printhead carriage.

10. Swing the lever (6) again into the position shown in figure D-2.

11. Tighten the locking screw (5) completely. Do not over-tighten the locking

screw (5).

Fig. D-3 Changing Printhead (II)

1 10 11 9 12 6

Appendix D - Replacing Assembly Units

1 2 ... 106 107 108 109 110 111 112 113 114 115 116 ... 119 120

Sin comentarios

CAB A8+ Manual del operador Pagina 111