CAB A8+ Manual del operador descargar pdf (Pagina 116)

E-2 cab Produkttechnik GmbH & Co KG

8. In the event an error occurs during the updating process, the error code

will be displayed on the LCD:

'C' : Check sum error (possibly "/b" missing in COPY command or

a corrupt firmware file)

'H' : Header fault (possibly "/b" missing in COPY command or a

corrupt firmware file)

'E' : EPROM could not be erased

'V' : Programming voltage too low

'P' : Programming fault

NOTICE !

If any one of the faults described above occurs, the previous firmware

setting is invalid and the update has to be started again. In some special

cases, it is possible that the printer will not return to normal operation

mode after powering on after a failed firmware update. In this case,

upload a previous firmware file over the parallel interface after powering

on.

Appendix E - Firmware Updates

1 2 ... 111 112 113 114 115 116 117 118 119 120

Sin comentarios

CAB A8+ Manual del operador Pagina 116