
D-2 cab Produkttechnik GmbH & Co KG
Fig. D-2 Changing Printhead (I)
WARNING !
Unplug the power cord from the power source before starting!
1. Swing the lever (6) clockwise until it stops and swing down the plate (8) as
shown in figure D-2. Remove the media from the printer.
2. Swing back the lever (6) to the position shown in figure D-2. In this
position, the printhead assembly is unlocked but still lying on the print
roller.
3. Loosen the printhead locking screw (5) using the Allen key (7).
5
6
1
7
8
Appendix D - Replacing Assembly Units
Comentarios a estos manuales