CAB Apollo 1 Manual del operador descargar pdf (Pagina 98)

98 cab - Produkttechnik GmbH & Co KG / Tharo Systems, Inc.

By using the cut/peel-off adapter it is possible, to operate the Apollo with cutter

assembly or present sensor in a special mode, where the print of one label can

be started by an external start signal.

In the peel-off mode, after removing a label from the peel-off position the use of

the adapter avoids the immediate print of the next label.

In the cut mode the print job can be divided in single prints.

In both cases, a label will only be printed, if it is required (cut/peel-off on

demand).

1 - 15-pin SUB-D connector for cutter

assembly or present sensor

2 - 9-pin SUB-D connector for an external

release switch

3 - 15-pin SUB-D plug to connect the

adapter to the peripheral port of the

Apollo

Pin Assignment of the 9-pin SUB-D Connector

Pin 1/2 - Optocoupler inputs. A short impuls of 24V= at the pins (+ at Pin1, - at Pin2)

releases the print of one label (external start signal).

The start impuls has to be shorter than the print time of the label. The current is

internally limited to 10 mA.

with present sensor : the print is released, if there is no label in the

presentation position

with cutter assembly : the print including the following cut is released

1 2 3

Front side Back side

Pin 5 Pin 1

Pin 6Pin 9

Connectors

Cut- / Peel-off Adapter

Fig. 13 p Connectors of the cut-/ peel-off adapter

Fig. 13 q 9-pin SUB-D connector of the

cut- /peel-off adapter

1 2 ... 93 94 95 96 97 98 99 100 101 102 103 ... 138 139

Sin comentarios

CAB Apollo 1 Manual del operador Pagina 98