CAB Apollo 1 Manual del operador descargar pdf (Pagina 14)

14 cab - Produkttechnik GmbH & Co KG / Tharo Systems, Inc.

Processor : 32 Bit, Motorola

Memory : Internal memory 2 MB

Interface : Serial : RS-232, RS-422, RS-485 8Bit 1200-57600 Baud

Parallel : Centronics

Peripheral port : 15 pin SUB-D connector

for cutter, present sensor, or applicator

Test features : System test when switching on

Self test with printout of firmware data and system parameters

Label material and Thermal paper, normal paper, plastic foil,

continuous media : PE, PP, PVC, Polyamid

Adhesive labels : 60-160 g/sqm

Tag Stock : up to 180 g/sqm

Label width .5 to 4.6 in (12-116 mm)

Label length : .2 to 21.5 in (5-546 mm) Apollo 1/2

.2 to 36.8 in (5-934 mm) Apollo 3/200M

.2 to 16.4 in (5-417 mm) Apollo 3/300M

Core diameter : more than 1.6 in (40 mm)

Supply roll diameter : up to 8 in (200 mm)

Label rewind : inside and outside

Internal rewinder : Core diameter : 1.6 in (40 mm)

Max. rewinding diameter : 5.7 in (145 mm)

In dispense mode, media rolls of up to 8 in (200 mm) diameter may

be used.

Material recognition : Gap sensor ("see-through")

Bottom-reflective sensor

Top-reflective sensor (Apollo 1/2 only)

adjustable from .12 to 1.9 in (3-48 mm)

Transfer ribbon: Length : 1,182 in (360 m)

Outer diameter : 3 in (74 mm)

Core diameter : 1 in (25 mm)

Inkside : in or out

Ribbon Saver : The ribbon saver starts from an unprinted length of .5 in (12 mm).

(Apollo 1 only) Then, during label feed, the printhead will be lifted, and the transfer

ribbon will be paused from feeding.

Backfeed : In order to always start from the front edge of the label, in dispense/

cut mode the label strip may be fed back after completion of the

previous print job.

To avoid smudging of the transfer ribbon onto the label material, the

printhead can be lifted during backfeed. (Apollo 1 only)

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 138 139

Sin comentarios

CAB Apollo 1 Manual del operador Pagina 14