CAB Apollo 1 Manual del operador descargar pdf (Pagina 61)

61cab - Produkttechnik GmbH & Co KG / Tharo Systems, Inc.

Peel Position

Using the optional present sensor, the "Peel position" parameter allows you to

alter the position of the dispensed label relative to the dispense edge.

Normally, with the initial offset value of "0" the label is removed from the carrier

ribbon until only a .08 in or 2 mm wide part of the label still sticks on the ribbon.

Adjustments have to be carried out only once when a present sensor is being

installed. (range from -.33 to +.33 in or -8.4 mm to +8.4 mm)

If the peel position value is positive, the label will be removed further leaving a

smaller strip sticking on the carrier ribbon.

NOTICE !

It is recommended that you alter the parameter for single print jobs via

software (e.g. if an applicator is used and, therefore, the labels have to be

removed completely). The software provides a second value for individual

adjustments.

You may also change this value using the software commands. Any front

panel value and software command value are totaled together for printing.

The current field to be changed is flashing in the display.

5 Cut Position

7 Printhead pos.

6 Peel Position

Peel Position

+ x.x mm

Peel Position

- x.x mm

Peel Position

± 9.x mm

Peel Position

± 0.x mm

Peel Position

± x.9 mm

Peel Position

± x.0 mm

Peel Position

± x.x mm Yes

Peel Position

± x.x mm No

Confirmation

Sign (+ or -)

1/10 mm

Fig. 9 g Set "Peel Position" parameter

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 138 139

Sin comentarios

CAB Apollo 1 Manual del operador Pagina 61