CAB Apollo 1 Manual del operador descargar pdf (Pagina 56)

56 cab - Produkttechnik GmbH & Co KG / Tharo Systems, Inc.

Transfer Print

The parameter "Transfer print" is used to set the Apollo to the print mode,

either direct thermal printing or thermal transfer printing.

This setting has an influence on two factors. On one hand, in thermal transfer

mode the printer works at a lower heat level compared to the direct thermal

printing mode. On the other hand, the ribbon sensor is only active in thermal

transfer printing mode.

NOTICE !

This parameter can also be changed via software. For different print jobs

it is recommended to make all changes in the software.

Default Setting : Transfer print ON

Transfer print

Off

Transfer print

xxx Yes

Transfer print

xxx N o

Selection

Confirmation

Fig. 9 c Set "Transfer print" parameter

1 Country

2 Transfer print

3 Label sensor

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 138 139

Sin comentarios

CAB Apollo 1 Manual del operador Pagina 56