CAB Apollo 1 Manual del operador descargar pdf (Pagina 77)

77cab - Produkttechnik GmbH & Co KG / Tharo Systems, Inc.

1 Firmware Version

Type of device, part number, and date of the firmware version.

2 Setup and Status Information

Country : Setting of the "Country" parameter

Print mode : Setting of the "Transfer print" parameter

Label sensor : Setting of the "Label sensor" parameter

Interface : Setting of the "Interface" parameter

Cut Position : Setting of the "Cut position" parameter

Peel Position : Setting of the "Peel position" parameter

Printhead Pos. : Setting of the "Printhead position" parameter

Heat level : Setting of the "Heat level" parameter

Test result : Result of the system test.

Any errors will be shown coded as four digit

hexadecimal numbers. (see Table 10)

(for fault correction see Appendix C)

/C shows when the setup has been altered from the

defaults. (Apollo 1 and Apollo 2 only)

For Apollo 3, the letter behind the "/" sign indicates

the state of modification of the hardware. (board)

Operative time : Cumulative operating time of the printer

Number of labels : Cumulative amount of printed labels

Thermal transfer : Cumulative length of printed material in thermal

transfer mode

Thermal direct : Cumulative length of printed material in direct thermal

mode

Date/Time : Setting of system date and system time

Character set : Setting of the "Character set" parameter

Temperature : Printhead temperature

Heat voltage : Current value of heat voltage

(approx. 24V / Apollo 3/300M approx. 20 V)

Brightness : Service information on brightness used at gap sensor

Peripheral device : Type of device connected to peripheral port

Memory card : Type and capacity of memory card (PCMCIA/PC card)

1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 138 139

Sin comentarios

CAB Apollo 1 Manual del operador Pagina 77