CAB Apollo 1 Manual de usuario descargar pdf (Pagina 32)

ENG-31cab - Produkttechnik GmbH

Key Assignment

The Apollo can easily be adjusted to the keyboard configuration of the particular

country by using the setup parameter "Country". For each of the available settings

the Apollo has a different table of key assignment, which, generally, complies with

the assignment under Microsoft DOS.

The [ALTGR] key has no function. Therefore, all signs which are located on the

right hand side of the key opposite of the normal characters (e.g. { } [ ] \) can be

generated by pressing the [ALT] key. A few of the other special signs (e.g. ¨ × ÷)

may also be generated the same way.

Other special characters (e.g. ñ ç œ) can be generated by inserting two characters

one after the other, where the second input is a combination with the [ALT] key.

Some of the special characters cannot be shown in the display of the printer. In

that case, the Apollo will use a character which looks similar to the required

character.

When using a scanner, the character set of the scanner has to be the same as

used by the Apollo.

Special Key Functions

[F1] To enter the list of labels stored on the memory card.

[F2] To repeat the print of the last label. (as command A 1 CR)

[F3] To repeat the print of the last label including a new enquiry for variable data.

[Shift]+[F5] To start the monitor mode/ASCII dump mode.

[Shift]+[F6] To start the self test printout.

[F7] Printer Info Display

[F8] Form feed

[ENTER] or Without a current print job : to switch between ONLINE and OFFLINE;

[RETURN] While processing a print job : to confirm the data input.

[ESC] To cancel the data input.

(while printing same effect as CANCEL)

[SPACE] While printing same effect as PAUSE.

[Shift]+[Del] To delete the input line.

[á],[â] To scroll up/down the list of labels on the memory card.

1 2 ... 27 28 29 30 31 32 33

Sin comentarios

CAB Apollo 1 Manual de usuario Pagina 32