CAB Apollo 1 Manual de usuario descargar pdf (Pagina 26)

ENG-25cab - Produkttechnik GmbH

131415161718

7 8 9 10 11

Inserting the Labels for Peel-off

1. Lift the printhead by turning the lever (7) clockwise until it stops.

2. Loosen the knurled screw (11) and swing media retainer (10) backwards.

3. Place the media roll (8) onto the media hub (9). Swing the media retainer (10)

to the media hub and inwards until it rests against the side of the roll. Tighten

the knurled screw (11).

4. Slide the two media guides (15/16) to their outermost position.

5. Unroll a length of media stock and feed it through the Apollo as shown in

figure. It is particularly important to ensure that the media strip slides properly

between the adjustable fittings of the photocell assembly (17).

6. Feed the media strip between the print roller and the thermal printhead, and

then over the dispense edge (19) up to the internal rewinder (14).

7. Slide the media strip from underneath the rewinder clamps (12) to the disc.

Fasten the media strip to the axle by holding the rewinder (14) and rotating the

knurled knob (13) clockwise until it stops. To tighten the media, rotate rewinder

counter-clockwise.

8. Slide the two media guides (15/16) against the edge of the media strip.

9. Lock the printhead by turning the lever (7) counter-clockwise until it stops.

10. Activate the peel-off function by selecting the peel-off mode in the software (in

direct programming use the "P" command).

If you do not use the printer for an extended period of time, lift the printhead to

avoid possible flattening of the print roller.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 32 33

Sin comentarios

CAB Apollo 1 Manual de usuario Pagina 26