CAB Apollo 1 Manual del operador descargar pdf (Pagina 61)

cab Produkttechnik GmbH & Co KG 61

[TABLE OF CONTENTS]

[COMMAND LIST][INDEX]

Hermes

Apollo

A-series

This

function is

available

for:

[ESC][i][L][S]

PRODUCT MARKING AND BARCODE IDENTIFICATION

q - query Printer

q l;name

Query for label. Requests if the label ( LBL ) file called "name"is available.

q m

Query for the memory card type Answer: Format „type, xxx kByte.CR“, - The

response will be „No card.CR“ if no memory card is attached to the printer

q p

Query for peripheral equipment. Reports the type of peripheral devices that

are connected. Possible responses are:

NONE, CUTTER,REWINDER, DEMAND SENSOR, BLOW ON, TRIGGER

(Applicator)

Used to verify if a label can be processed on the selected printer. Very helpful if

multiple printers with different peripheral equipments are connected.

q r

Query for ribbon diameter. Answer: diameter of the ribbon roll in millimeters.

If the ribbon roll has not been measured, the answer will be -1

(A-Series only , Firmware version V2.81 or higher.)

Can be used to get a early warning when the ribbon is close to be finished.

q s;name

Query for scaleable fonts. Answer Y/N or C if the font had been found on the

memory card.

This command is used to check if a specified font is available, to find out if it has

to be downloaded (again).

q t

Query for time and date Answer: yymmddhhmmss CR

Time and date format is identical to the "s" -command.

Used to find out if the printer´s date and time must be synchronized or to keep

track when a label was printed.

Syntax:

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 254 255

Sin comentarios

CAB Apollo 1 Manual del operador Pagina 61