CAB a4 Manual de usuario descargar pdf (Pagina 17)

17

During the print and apply cycle the pro-

duct remains ﬁxed. The universal tamp ist

covered by a foil. According to the size of

the label the holes can be pierced. The

tamp pads are customized to the dimen-

sions of the label sizes on request.

For applying pressure to sensitive products

the label can be blown onto the product

with the supporting air jet stream. The

print and apply cycle performs in a ﬁxed

position or in a linear movement of the

product. The blow pad moves to a pre

adjusted position approx. 10 mm away

from the product.

Using the roll-on pad the label is dispen-

sed until it touches the roller. The tamp

pad moves on top of the product. The

label is then rolled on and applied by the

movement of the product.

Tamp pad Blow pad Roll-on pad

The lower frame can be customized

according to the special requirements

regarding width and height. The print

and apply system is positioned by adjus-

ting two bolts. The exact position of the

system can be adjusted on a guide rail.

The stand enables the fast and ﬂexible

application of the printer in every ma-

nufacturing line. The labelling position is

easy to adjust in height and width. Four

guide rollers at the undercarriage provide

for mobility. It is adjusted with bases at

the place of installation.

Lower frame

The stand for ﬂexible printer mountingPrinter on lower frame

The print and apply system is mounted

on a base plate with a thickness of 10 mm

and can be ﬁxed with only one clamp.

Stand

Printer holder

for A4

+

and A6

+

,

A2

+

on request

Accessories I Applicator

Total height mm 1600

Labelling height up to mm 1400

Projection mm 230 - 500

Undercarriage

(base distance)

Width x Depth x Height mm 600 x 860 x 140

Stand

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 23 24

Comentarios a estos manuales

Sin comentarios