CAB A6 Manual del operador descargar pdf (Pagina 121)

D-3cab Produkttechnik GmbH & Co KG

A3-2 / A3 / A4 / A6

CAUTION !

The following instructions do not apply for A6 ! If you try to pull the label

edge sensor out of the A6 as described below, the sensor cable could be

torn off from the sensor ! For that reason, on A6 the cleaning of the label

edge sensor must be done by a service technician !

During operation of the printer, paper dust can accumulate on the label edge

sensor. In some cases, this may lead to problems when sensing the media.

If this is the case, you should clean the label edge sensor.

CAUTION !

Do not use solvents to clean the label edge sensor!

Do not use sharp objects to clean the optical sensor!

1. Remove the media from the printer.

2. Press the latch (1) in the direction of the arrow in figure D-1.

3. Continue pressing the latch and pull the label edge sensor (2) with the

handle (4) to its outermost position.

CAUTION !

The label edge sensor cannot be removed totally ! There is a stop when

the label edge sensor reaches the outermost position ! If you try to pull

further the label edge sensor can be damaged !

4. Clean the label edge sensor and its optical sensors (3) with a soft brush or

a cloth dipped in isopropyl alcohol.

5. Slide the label edge sensor back into its original position.

Fig. D-1 Cleaning the Label Edge Sensor

Cleaning the Label Edge Sensor A3-2/A3/A4

Appendix D - Maintenance / Cleaning

1 2 ... 116 117 118 119 120 121 122 123 124 125 126 ... 137 138

Sin comentarios

CAB A6 Manual del operador Pagina 121